Published:2009/7/1 3:38:00 Author:May | From:SeekIC
C1 in series with the crystal may be used to adjust the oscillator output frequency. Value may range between 20 pF and 0.01 μF, or may be a trimmer capacitor and will approximately equal the crystal load capacitance. X values are approximate and can vary for most circuits and frequencies; this is also true for resistance values. Adequate power supply decoupling is required; local decoupling capacitors near the oscillator are recommended. All leads should be extremely short in high frequency circuits.
Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Signal_Processing/Oscillator_Circuit/LOW_FREaUENCY_CRYSTAL_OSCILLATOR_10kHz_to_150_kHz.html
Print this Page | Comments | Reading(3)
Code: